How to Control of The Fork Movements for Linde K10 K13

This instruction will show you how to control of the fork movements for Linde K10 K13.

 

Preparation:

Linde Truck Doctor v2.01.005 Diagnostic Software Installation Service.

 

Methods:

Two-hand control

To  select any movement, it is first necessary to press the relevant preselection key and then select both the required direction and  the speed by deflecting the control lever on the opposite side.

Important:

In order to influence the damping control and other transitions, it is necessary to first  select  the required movement using the relevant "preselection counter" and then to deflect the control lever.

Raising - lowering the cab lift

•  Press the preselection key (1) on the right

•  Using the left-hand control lever (2), select the direction of movement and the speed (or if applicable see diagonal travel). 

Raising - lowering the auxiliary lift

•  Press the preselection key (3).

•  Using the left-hand control lever (2), select the direction of movement and speed.Shifting the forks

•  Release the dead-man brake (activates brake). Press the preselection key (4).

•  Using the left-hand control lever (2), select the direction of movement and speed.Swivelling the forks 

•  Release the dead-man brake (activates brake). Press the preselection key (5).

•  Using the left-hand control lever (2), sel-ect the direction of movement andspeed.Diagonal travel Only possible inside an aisle.

•  Press the dead man brake (releases brake)

•By deflecting the two control levers in the corresponding direction, the movements "Drive forward-back" and "Raise lower cabin lift" can be combined at will.Both movements can be steplessly con-trolled.