Leaking Shower Head? No Problem!! Here Is the Solution
A
leaking shower head can go unnoticed and undetected right under your nose for
months. You will never feel the necessity of shower repairs Brisbane until the
situation gets worse. The reason is that the shower head or the entire shower
is hidden behind a curtain of a glass partition. As it goes unnoticed, you will
never know how much water you have wasted and how much money you have paid as
water bills for wasting that water.
Timely
shower repair is the only solution, and in fact, this repair work should start
as soon as the first drop is detected. Fixing your shower head requires
repairing one or more components that combine to make up a shower system. You
might have to engage in –
• Unclogging the shower head
• Replacing worn washers
• Replacing the diverter valve
• Replacing a problem cartridge valve
Why
Is My Shower Head Leaking?
There
could be several reasons behind the leakage in the shower head area. The water
that flows up through the shower head comes from the faucet located in the
wall. The faucet is below the shower head, and in most cases, the water
pressure diverted from the tap becomes a reason for leakage. Also, a worn-out
shower head or the O-Ring is responsible for the leakage. Experts involved in
offering shower repairs services say that the leakage from the shower head
could be due to one issue in the shower head or a combination of other problems
with the issue in the shower head area. They further add that finding the
answer to this question will depend on the answers of the following questions.
Does
The Shower Head Leak Constantly, Even When The Faucet Is Off?
If
this is happening, the problem lies in the shower faucet area, but this will
also depend upon how long this has been going on. The shower head alone can
also be responsible for this.
Does
Your Shower Head Drips For A While After The First Is Shut Off And Then Stops
Completely?
If
this is the situation at your home, the issue is definitely with the shower
head part.
In
short, it can be said that the shower faucet and shower head are the two parts
most responsible for leaking showers. For shower repairs, local plumbers will
inspect the area to determine the proper root cause. The shower head is easier
to repair as compared to the first part because you just have to shut off the water
to the bathroom and start the repair work.
Unclogging
The Shower Head
The
following steps involve unclogging the shower head area for shower repairs
Brisbane.
Shut
Off The Water Supply
The
shower plumbers offering shower repair services will shut off the water supply
and remove the shower head with a wrench from the pipe that comes out from the
wall.
Inspection
The
second step involves inspecting the holes in the shower head area, and if they
appear blocked by minerals, the plumbers will clean them. If they detect
leakage there, they will give the shower head a good soak and then reinstall
it. This soaking is done in white vinegar for almost 8 hours.
Further
Inspection
As
a part of shower repair, local plumbers will also inspect the washer or the
O-Ring on the back of the shower head. If it is damaged or worn out, they will
pull it out and replace it with a new O-ring.
To
replace the O-Ring or the rubber washer, they will first open the faucet handle
by unscrewing it. The screw is commonly hidden behind the decorative cap, and
once the handle is removed, they will remove the dirt with the help of a deep
socket wrench. Then, they will replace the old rubber washer with a new one and
assemble back the entire system.
Soaking
Is Complete
After
this soaking period is over, the plumbers will free the holes with a toothpick
and then scrub the faucet entirely and clean it with a stiff brush. Any debris
stuck there will be removed, and after rinsing the shower head area, they will
reinstall it and test for leakage.
Comments